Chat with the Behringer Cat Manual
Get instant answers about your Behringer Behringer Cat. Ask questions like "how do I set up MIDI?" or "how do I save patterns?"
📖Chatting with Behringer Cat Manual
Common Behringer Cat Questions
How do I sync the Behringer CAT to my DAW via MIDI and use it as a sound module?
Connect the MIDI output of your audio interface to the MIDI input of the CAT. Configure your DAW to send MIDI clock to the CAT and select the CAT as a MIDI output device on the desired track.
Does the Behringer CAT store patches or sequences, and if so, how do I save and recall them?
The Behringer CAT is a fully analog synthesizer and does not store patches or sequences digitally. You must manually recreate sounds and sequences each time.
What are the basic steps to create a simple duophonic sequence using the CAT's built-in sequencer?
Engage the sequencer, select the number of steps, and then use the potentiometers on the CAT to adjust the voltage for each step. Activate the keyboard trigger or external clock source to start the sequence.
My Behringer CAT isn't producing any sound, what should I check?
First, ensure the volume knob is turned up, then verify that both oscillators are active, the VCF is open, and that the gate/trigger source is properly connected/enabled. Also, check all cable connections.
What is the difference between the two oscillators on the Behringer CAT, and how can I use the duophonic mode effectively?
Oscillator 1 provides Triangle, Sawtooth, Pulse and Sub-Octave waveforms, while Oscillator 2 provides Sawtooth, Pulse, and Ramp waveforms. In Duophonic mode, each oscillator can be assigned to a different note, allowing you to play two-note chords or create evolving textures.