Chat with the RME Fireface 802 FS USB 2.0 Audio Interface Manual
Get instant answers about your RME RME Fireface 802 FS USB 2.0 Audio Interface. Ask questions like "how do I set up MIDI?" or "how do I save patterns?"
📖Chatting with RME Fireface 802 FS USB 2.0 Audio Interface Manual
Common RME Fireface 802 FS USB 2.0 Audio Interface Questions
How do I set up MIDI devices with the Fireface 802 FS?
Connect your MIDI devices to the Fireface 802 FS MIDI I/O ports, then configure the MIDI ports within TotalMix FX by enabling the respective MIDI inputs and outputs for your connected devices. Ensure the MIDI mode in TotalMix FX settings is set according to your MIDI device requirements.
How can I save and recall TotalMix FX routings and settings as presets on the Fireface 802 FS?
Within TotalMix FX, use the 'Snapshot' function to save your current routing and mixer settings as a preset; you can then recall these presets later from the Snapshot menu or assign them to MIDI Program Changes for quick access.
What's the basic workflow for routing audio with the Fireface 802 FS using TotalMix FX?
In TotalMix FX, each hardware input and software playback channel is routed to a hardware output using faders; adjust these faders to control the signal level sent to each output, creating custom monitor mixes and routing paths.
My Fireface 802 FS is not being recognized by my computer, what should I do?
First, ensure the device is properly connected via USB 2.0 and powered on; then, verify you have the latest RME drivers installed for your operating system and check the USB port for any potential issues.
What is the DURec feature on the Fireface 802 FS and how do I use it?
DURec (Direct USB Recording) allows you to record all inputs directly to a USB storage device connected to the interface without a computer, simply connect a drive to the USB port on the front panel and use the DURec controls within TotalMix FX to start and stop recording.