Chat with the Dreadbox Murmux Manual
Get instant answers about your Dreadbox Dreadbox Murmux. Ask questions like "how do I set up MIDI?" or "how do I save patterns?"
📖Chatting with Dreadbox Murmux Manual
Common Dreadbox Murmux Questions
How do I save and load presets (Kits) on the Murmux?
To save a Kit, press and hold the 'WRITE' button, then select a Kit slot using the 'MODE' buttons 1-8. To load a Kit, simply press the corresponding 'MODE' button (1-8) without holding 'WRITE'.
My Murmux isn't responding to MIDI notes, what should I check?
First, ensure that the Murmux's MIDI channel (set via the rear panel DIP switches) matches the MIDI transmit channel of your controller or DAW. Also, verify that your MIDI cable is properly connected and functioning.
How do I set the sequencer length and create patterns?
The sequencer length is determined by the number of active steps; use the 'STEP' buttons to enable or disable steps. To record a pattern, press 'REC', then play notes on the keyboard while the sequencer runs.
What's the difference between the 'LFO' and the 'MOD' sections, and how do I use them?
The 'LFO' is a dedicated Low Frequency Oscillator with various waveforms for general modulation tasks, while the 'MOD' section is a more complex modulation matrix that allows you to route different sources (like the Envelope or another LFO) to various destinations for more intricate sound design.
I'm getting a lot of noise in my signal; what could be causing it?
The Murmux's oscillators can be sensitive; ensure proper gain staging throughout your signal chain and experiment with slightly lowering the oscillator levels. Also, consider using balanced cables if you're experiencing ground loop issues.